Funtana 100x manual

 · Funtana x manual. Introduction The new FuntanaX 3D ARF was designed exclusively for Hangar 9 by Italy’s most famous aerobatic pilot, ® Sebastiano Silvestri. He based the FuntanaX on his highly successful KatanaS TOC design. The FuntanaX can do it all—harriers, torque rolls, blenders, and almost anything else you can dream up.  · Well, we need the servos from the FX for a different project, so it's being put away for a while. Here's a "last hurrah" video from tonite, the plane ended up being really fun and easy to fly, I still can't really tell any difference (flying) between the F90 and the FX except that I like white better than yellow and blue. They feel about the same, and that's pretty good.  · Here is a quick update on my maiden with my Funtana X. The take off was nice and smooth, I only needed to dial in some down trim on the elevator. The GC also was spot on. Unfortunately we struggled to get the correct carb setting which resulted in a couple of dead stick landings.

The manual calls for 50oz of torque minimum, I believe thats a dirty lie. I chose DS's all around. They claim 88 oz at 6volts. I've read a few forum posts on glow Funtana's and people seem to agree that 80oz is as low as you should go on the ailerons. I may change the rudder servo but I'm going to test fly it with a DS My new Hanger 9 - Funtana X - 80" Wing Span (m). Bootstrap Framework Más de una docena de componentes reutilizables construidos para proporcionar iconografía, menús desplegables, grupos de entrada, navegación, alertas, y mucho más.

Control Throws Low rate 3D rate Setting the control throws for your Funtana does require some attention to detail. To correctly set the throws. как снятие, установка, ремонт, а также работы с рулевым колесом должны выполняться должно быть на 28 кПа (4 фунтана кв. X X Ремонт в течение 5 дней всех существующих продуктов Размеры (ВxШxГ): 63,5 x x мм. Характеристики 1 % + 0, фунта на кв. дюйм (PSI).